Cisco 공인 네트워크 어소시에이트(CCNA 200-125)

회차 · v.2017-09-22

You are configuring Open Shortest Path First (OSPF) protocol for IPv6 on Router5. The router has two interfaces, which have been configured as follows:
----------
S0/0 - 192.168.5.1/24
S0/1 - 10.0.0.6/8
----------
You would like OSPF to route for IPv6 only on the S0/0 network. It should not route for IPv6 on the S0/1 network. The process ID you have chosen to use is 25. You do not want to apply an IPv6 address yet.

Which of the following command sets would enable OSPF for IPv6 as required?

하나 선택Router5(config)#ipv6 ospf 25 Router5(config)# network 192.168.5.0Router5(config)#ipv6 ospf 25 Router5(config)#router-id 192.168.5.1Router5(config)#ipv6 unicast-routing Router5(config)#ipv6 router ospf 25 Router5(config-rtr)#router-id 1.1.1.1 Router5(config)#interface S0/0 Router5(config-if)#ipv6 ospf 25 area 0Router5(config)#ipv6 unicast-routing Router5(config)#ipv6 ospf 25 Router5(config-rtr)#router-id 1.1.1.1

문제 목록·복습

정답오답미응답

문제 링크

시험 기본정보

Cisco Certified Network Associate(CCNA 200-125) 시험은 네트워크 기초, LAN 스위칭 기술, IPv4 및 IPv6 라우팅 기술, WAN 기술, 인프라 서비스, 인프라 보안 및 인프라 관리와 관련된 응시자의 지식과 기술을 테스트합니다.